Monday, September 25, 2017

Tarheel Screwdriver Antenna Mount

This weekend i took some time to get my new Tarheel screwdriver antenna mounted. after rebuilding it about 6 time the is what i came up with and its working grate. Very Sturdy.


This is the start of the plate that ill bolt the back of my jeep along with the overhead rack. the bolts are 5/8 so i have punched and drilled smaller holes to guyed the lager bit.


Here i have the insulator for the top mount. not complete a this point as it will have flat stock
welded the toe back so i can bolt it to the rack


Stainless steel 5/8 bolt i faced in the lathe, the taped it for the screw


The insulators i turned in the lathe. They are made out of cutting board plastic because this 
is all i had. 

As a side note this is not the best plastic to use for out doors because it will brake down in the weather. Delrin is what is used most of the time for this, and i have some on order now to replace them soon 


This bolt i reused form a heavy duty cb antenna mount i broke some time back. the top is 3/8x24 and the bottom is threaded for the 5/8 bolt.



All put together on the mount


Top insulator made out of the same cutting board plastic 


the other side



Mounted to the truck with the coax and grounding strap to the frame. ill be adding a cover to this to keep mud and dirt off of it. 


1 comment:

  1. It was really insightful.
    Thanks for such a nice content.
    Cheers
    BTW if anyone interested more have a look batterymodeon thanks

    ReplyDelete